Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NM-1FE-TX, dot1q and 2620 routers

Status
Not open for further replies.
networknewb

networknewb

MIS
Feb 10, 2011
6
US
Hi,
I have done some research on this and know that the built-in Fast Eth port on the 2620s handles dot1q. Does anyone know if the NM-1FE-TX add-in cards will support dot1Q? Is it solely dependent on the IOS ver, or do they not support it at all on any routers less than 3600 series?
Thanks!
 
Status
Not open for further replies.

Similar threads

Lccarter
  • Locked
  • Question
Cisco CUCM Provisioning and Order Management System
Replies
1
Views
154
Lccarter
Lccarter
detewe
  • Locked
  • Question
JTAG pinout on Linksys E4200v2 / EA4500 routers
Replies
0
Views
116
detewe
detewe
acabezas2014
  • Locked
  • Question
Need to create QoS for SNMP and Radius traffic on Cisco 4948 Switches
Replies
0
Views
82
acabezas2014
acabezas2014
mrdom
  • Locked
  • Question
RV325: Accessing LAN and WAN resources using the same hostname ...
Replies
0
Views
76
mrdom
mrdom
dmourghen
  • Locked
  • Question
PBR issue and Access-list
Replies
0
Views
90
dmourghen
dmourghen

Part and Inventory Search

Sponsor

Back
Top