Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Nitsuko 124i
- Thread starter stephany1
- Start date
- Thread starter
- #3
Thanks for your response, these are my 2 problems better explained:
Using a test cabinet configured:
DTSU PCB in slot1,
T1 PCB (set for PRI) in slot3,
4ATRU in slot4
4DTDU tone card in slot8.
I cannot get my T1 to sync with my new adtran csu-ace. My csu is in sync with the telco and a loop-back test shows it is good on the CPE side.
With my cable coming from the PRI card, I have the pairs on pins 1,2 & 4,5 into the back on the adtran on an rj45 connector. However, there remains no sync.
Is this correct?
The system has also been reset and prog. 0004 run on an empty slot3 and then re-run with the T1 card in slot3 to ensure successful install of the card.
Note: There is an EXPRU installed as required. Software now v6.02.00P.
Do you have any ideas as to what is wrong here?
Secondly,
I wanted to go on site from my lapbu to my laptop, but I have not been successful. I think prehaps I do not remember the correct connections and/or program. I want to make sure my system acknowledges the installation of the T1 card in slot3.
What is the correct connection?
I have the software for the 124i and I have tried Me to PC.
Your help will certainly be appreciated
Using a test cabinet configured:
DTSU PCB in slot1,
T1 PCB (set for PRI) in slot3,
4ATRU in slot4
4DTDU tone card in slot8.
I cannot get my T1 to sync with my new adtran csu-ace. My csu is in sync with the telco and a loop-back test shows it is good on the CPE side.
With my cable coming from the PRI card, I have the pairs on pins 1,2 & 4,5 into the back on the adtran on an rj45 connector. However, there remains no sync.
Is this correct?
The system has also been reset and prog. 0004 run on an empty slot3 and then re-run with the T1 card in slot3 to ensure successful install of the card.
Note: There is an EXPRU installed as required. Software now v6.02.00P.
Do you have any ideas as to what is wrong here?
Secondly,
I wanted to go on site from my lapbu to my laptop, but I have not been successful. I think prehaps I do not remember the correct connections and/or program. I want to make sure my system acknowledges the installation of the T1 card in slot3.
What is the correct connection?
I have the software for the 124i and I have tried Me to PC.
Your help will certainly be appreciated
- Status
Similar threads
