Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

nfuse 1.5

Status
Not open for further replies.

cyjae

IS-IT--Management
Nov 21, 2000
16
US
I have installed Nfuse 1.5 on my Web server I.P. 2xx.xxx.xxx.xx
Forrestinc.com (link at spinning logo)
I have installed WebWizard on the Citrix servers

Citrix servers have the following I.P.’s

Gaylord FARM
Server1
2xx.xxx.xxx.xx / 192.xxx.x.x(two nics)
Server2 192.xxx.x.x (one nic)

I have used ALTADDR to set alternate address on 1st. server
I have modified the .ica to UseAlternateAddress, then created the .htm

All apps. work from within on local addresses through the Web pages of our Web server.
Proxy server is configures for all internal I.P.s 192.168.0.1
Two nics 192.xxx.x.x / 2xx.xxx.xxx.xxx
Ports 1494 and 1602 are open on the Proxy server

I can access the login.htm from “outside”.
I can get authorized.
I can get to the appslist.
However when I attempt to access an app. I receive an error stateing
“there is no Citrix server configured on this address”

Any suggestions would be helpful.
 
Did you copy the Address=[NFuse_IPV4Address(Alternate)] line as-is from your template.ica file? If so, this line has a syntax error in it.

Remove the parenthesis that surrond the ALTERNATE section. This should read [NFuse_IPV4AddressAlternate].

There are other reasons why this message appears, but I have found this to be the most common.

I hope this helps
 
I have the correct line . I typed it in and have since verified it is correct.??????????
 
Are you putting in the ICA Master Browser in the clients Server Location fields? If the name doesn't work, try using the IP address.
 
Yes.
I managed to get it working from "outside" by changing the I.P. address in the templet.ica to our internal address. However now it does not work from inside. If I replace the address with our "outside" address it works inside but not outside.

Apparently with UseAlternateAddress it comes in from uotside on our external I.P. then changes to the internal I.P. and functions as it should.

Do you think I need to set up two seperate access site on our HOME page. One for those "outside" and one for those "inside"?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top