NFCR on Did trunks is it possible??

[s3k]

friends
I have DID trunks pointing to the telco loop.
Can i configure access restrictions based on NCOS/NFCR on these trunks.
I had configured the same on TIE trunks and woring fine, but cant do this on DID trunks( MERL also says can't).
Is there any other way i can set it up?

What i did with TIE trunks was:
ld 15 enabled nfcr
ld 87 define ncos and associated with Frl
ld 49 made code Restriction tree
Ld 16 associated with an FRL.
ld 14 assign Cls TLD to trunks
ld 11 assign ncos and tld to extension

But we cant enable this for trunk type DID, is ther any other soloution on DIDs.


immediate hel pls!

Think Globally, Act Locally

 

[hawks]

What are you trying to do?

 

[s3k]

yeah
i wanna make some groups..
say group 1 give permission for international calls
group 2 allow only local calls without mobile
group 3 allow local and mobile calls
etc and assign this over the did trunks


Think Globally, Act Locally

 

[hawks]

Are they built as 2 way DID's or just inbound only?

 

[s3k]

its 2 way dids, inb and outb..

Think Globally, Act Locally

 

[hawks]

If you can dial out on them then you should be able to use restrictions on them.

 

[Reusser]

You will need to use NARS programming
LD 86 - build RLIs with route and FRL info for different access levels
LD 90 - Build NPAs, NXXs, SPNs assigned to RLIs