Hi everyone,
Forgive my ignorance on the matter, but I am in a new environment with a cisco pix firewall and need a little clarification on a few things. Basically, I need to go into my pix firewall and open up a few ports for vpn support. My question, though, is at the most basic level - how do I go about adding lines of code to my configuration, like opening these ports, without overwriting the existing configuration? Is it possible to do this through telnet? Any suggestions on commands to use and best practices would be appreciated.
JerryL
Forgive my ignorance on the matter, but I am in a new environment with a cisco pix firewall and need a little clarification on a few things. Basically, I need to go into my pix firewall and open up a few ports for vpn support. My question, though, is at the most basic level - how do I go about adding lines of code to my configuration, like opening these ports, without overwriting the existing configuration? Is it possible to do this through telnet? Any suggestions on commands to use and best practices would be appreciated.
JerryL