Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

New VAL board

Status
Not open for further replies.

m90dom

Technical User
Jan 7, 2014
10
GB
Hello, I have just added a new VAL board, I have adde3d the none name and ip address in.

When I go to ch ip-I (board location) I have enabled the interface added the correct node name, subnet mask and gateway

If I do a status link (link number) it says the Link status is disconnected! Can anyone tell me where I am going wrong?
 
Resolved! I was using the wrong connector at the back. I was using a DS1.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top