Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

New to CUCM - Phone doesn't show off-hook and doesn't answer call when handset goes off-hook

Status
Not open for further replies.

captnamo

Technical User
Feb 2, 2006
226
US
Brand new to CUCM, coming from the Nortel world. We have a phone (7841) with two line appearances, the user's extension and the office main line. When a call comes in and hand piece is lifted, user has to push a button to answer a call.

In the Nortel world, we would set LPK (last pickup key) to select which lines would be answered when off hook, and every line from the selected last key back to the first key (primary DN) could be answered when ringing when the phone handset went off hook.

The Cisco phone I'm sitting next to has a single line displayed (the primary DN) and goes off hook when I pick up the handset and I hear dial tone. I want the phone with two lines to engage the primary DN when lifting the handset (to hear dial tone without pressing a button) and to answer either line, if ringing, when lifting the handset.

What CUCM setting(s) am I missing on this device?
 
Always use prime line. By default its False. So you may need to make it false if your system is setup to be true by default.

Certifications:
A+
Network+
CCENT
CCNA Voice
CCNP Voice
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top