new T1 programming 1

[digitalgear]

What loads and prompts woud I need to build a new T1 install. I beleive I have to build a route first and use RLI to point it somewhere and then config the T1. Looking for the step by step instructions and what loads to use and to most important promps to be set. Also how do I know what loop it would be when installing T1 card. Any help would be greatly appreciated. I'm working with option 11's through 81's

 

[wdhb]

With out being condescending, maybe you should consider using a Meridian tech to set this up for you as there is quite a bit involved.
1. LD17 - configure the d-channel
2. LD17 - assign a loop to the PRA
3. LD16 - configure the route
4. LD14 - configure the channels.
5. LD86 - configure the RLB's & DMI's.
6. LD87 - set up DSC's or TSC's - if the PRA is a tieline.
7. LD90 - your choice of flavours if a telco route.
8. wire out the PRA to the network
9. install the card
etc