New Loop - QSIG PRI

[oneeyebrow]

Hello,

I am in the process of building a QSIG PRI and need to build a new loop. I am having trouble seeing if this can be done (system is in London). Here is the CEQU, MSDL and SUPL print out. I think I can use port zero on either MSDL card for the d-channel.

CEQU
MPED 8D
TERM
REMO
TERD
REMD
TERQ
REMQ
SUPL 012 028 V100 V104
N108 V112
SUPC
SUPF
DDCS
DTCS
XCT 000 016
TDS * 000 * 016
CONF * 001 * 017
MFSD * 000 * 016
PRI2 003 019
APVL
DTI2
MISP
SYNM 0
EXT0 3PE
CNI 009 000 000
EXT1 3PE
CNI 009 000 000
MCFN 509 MB

GROUP 0 MSDL 6: ENBL
GROUP 0 MSDL 7: ENBL
.stat msdl 6
GROUP 0 MSDL 6: ENBL
DCH 3 OPER PORT 1
.stat msdl 7
GROUP 0 MSDL 7: ENBL
DCH 19 OPER PORT 1

SUPL SUPT SLOT XPEC0 XPEC1 IPMG VXCT0/1 ZONE0/1 IPR0/1

012 STD LEFT 01 0 3 -- - - --- --- - --- ---------------
028 STD LEFT 02 0 3 -- - - --- --- - --- ---------------
100 ---- ---- VIRTUAL -- - - --- --- - --- ---------------
104 ---- ---- VIRTUAL -- - - --- --- - --- ---------------
108 ---- ---- PHANTOM -- - - --- --- - --- ---------------
112 ---- ---- VIRTUAL -- - - --- --- - --- ---------------

Any insight/advice is appreciated. Thanks.

 

[bhassell2000]

om the MSDL cards I have used I have had to change switch settings to make port 0 work for a dsch but it is doable. Do you have the QSIG packages?

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[oneeyebrow]

Not sure about the QSIG package, but the two ports being used on the MSDL cards currently have d-channels configured.

Thanks.