New CM 5.2.1 install onto a S8800 Server

[wontwork]

Hi guys,

I am currently doing a new install of a CM running R015x.02.1.016.4 on a S8800 server, everything has been fine until i rebooted the server.

When i rebooted the server it does not come back up but just sits in a continous reboot, i am able to access the system for a short amount of time where i can check the alarms which state:

almsummary:4:Unable to connect to CommunicaMgr

It then reboots again.

When i check the processes through the web pages they all say down, i then have to putty to the box and manually start the processes by typing the command start -ac.

All is ok until i do a reboot again!

I have applied the latest Cm 5.2.1 Service Pack which is 3 but i am still receiving the same issue.

Has anybody come across this before?

Thanks.

 

[AvayaPBXengineer]

have you connected a monitor onto the server when it boots up etc.

I had an issue whereby the server would go through the bootup process and it would hang when it couldn't find an ntp server and subsequently reboot.

 

[uzumaki]

I'll be installing the same in 2 months using E164 dial plan, hope avaya fix some issue before i install

 

[wontwork]

Unfortunatley i have not had a chance to connect a monitor to the server as i am in a remote location and do not have direct physical access to the server.