I'm setting up a new Cisco 857w -
No issues starting up SDM or the router, can login as cisco/cisco as-per instructions. From there I make all the configuration changes I need for the network I'm using by stepping through the wizard (I hate wizards however it won't let me do a http manual config and my IOS skills are VERY rusty).
When I get to the summary dialog, I can click finish, then I get the hourglass and nothing else happens. The router config does not change.
SDM does nothing else. I can click on "back" and edit the setup i have made, and make changes, but it still will not save. I have Telnet into router and user/pass is still "cisco" - IP does not change, etc. if I click cancel it just drops me out and I have to start again.
I have read of this issue in other forum, however have not seen any responses, anyone?
Pete
No issues starting up SDM or the router, can login as cisco/cisco as-per instructions. From there I make all the configuration changes I need for the network I'm using by stepping through the wizard (I hate wizards however it won't let me do a http manual config and my IOS skills are VERY rusty).
When I get to the summary dialog, I can click finish, then I get the hourglass and nothing else happens. The router config does not change.
SDM does nothing else. I can click on "back" and edit the setup i have made, and make changes, but it still will not save. I have Telnet into router and user/pass is still "cisco" - IP does not change, etc. if I click cancel it just drops me out and I have to start again.
I have read of this issue in other forum, however have not seen any responses, anyone?
Pete