New CallerID for 3.0?

[assistu]

I installed a 406 with a PRI and went to program the outbound callerID. So, I set up the short codes to send out the DID number.

Example:
SC: [9]1N;
TN: 1Ns925555E

It didn't work. The caller received to callerID at all. Talked to tech support and they said it should have been...

SC: [9]1N;
TN: 1Nsi925555E

Anyone else heard of this, or why they may have changed it? They could not offer any information about where this tidbit of crucial information might be located.

Thanks!

 

[sizbut]

The 'i' option has always been there. Whether you need to use it or not will depend on the service provider - its a case of try this one, if it doesnt work try this one.

 

[kflounders]

i sends the National signal in the US. It is needed on many providers here. It is not new.

 

[olbs]

As the others have said, no changes there. The "W" option has died/been killed/disappeared though