I had 3 terminals and needed to add a fourth one. After aloha provided the license key, I was able to install the terminal. However.... when it boots it just says determining file server ...0 and restarts. I have gone to the Aloha Admin UI and marked it for reload. Then ran the terminal reset... I can tell that it reloaded but still the same results after performing it twice. Thanks in advanced for your help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
New Aloha Terminal setup just says determining file server ...0 and restarts
- Thread starter NM360
- Start date
SirTekaLot
IS-IT--Management
Check the ibercfg.bat file for the correct settings.
- Status
Similar threads
- Locked
- Question
- Locked
- Question