Networking two magix systems

[kslusher123]

I'm trying to get two Magix systems networked together using a 100 DCD board in each system and a t1 crossover cable. I have followed the networking reference manual, checked the Magix manuals, but have been unsuccessful with getting the connnection up. I have one unit setup as Merlin-Ntwk and the other one set as Merlin PBX. The PRI programming is ESF B8ZS the clocking is set as local and loop. Any help would be appreciated.

 

[kwing112000]

How is your cable. It should be crossed 1,2 4,5. So 1 to 4 and 2 to 5.

Kevin Wing
ACS- Implement IP Office
ACA- Implement IP Office
Carousel Industries

 

[kslusher123]

Yes my cable is a t1 crossover 1 to 4 and 2 to 5.

 

[kslusher123]

I found the problem. One of the DCD boards I was using was bad.