Have a site with a BCM400 4.0 to be linked with a BCM200 3.7. I have 2 VOIP trunks licensed at both ends. Both ends connected to the network. Routing and gateway programming are done, but cannot call thru from either end. Calls from the BCM400 end sieze and dial as observed on Monitor. Calls from BCM200 end don't seize or dial. I would appreciate a list of things to check. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Networking BCM sites
- Thread starter Quiggly
- Start date
norstarboy125
Vendor
I take it you have proper keycodes?
Routes build?
Target lines?
Dest Codes?
Just a few things needed to get this going. I'd advise upgrading that 200 to at least 4.0 as well.
Charm City Communications
Routes build?
Target lines?
Dest Codes?
Just a few things needed to get this going. I'd advise upgrading that 200 to at least 4.0 as well.
Charm City Communications
- Status
Similar threads
- Question