ChaldoKid1
Technical User
I recently installed a new desktop at my job. We currently have a wired network set up with 6 computers. Once I was done installing Windows 2000 Professional (Service Pack 4), I plugged the CAT-5 cable into the existing switch. Everything looked fine, as all of the computers on the network became visible. I also attempted to connect to an already shared printer. The printer appeared on the network, so everything worked perfectly...For about 5 minutes. At first, I could print and everything worked fine. After a few minutes, it seems that the printer was somehow disconnected from the network connection. The following errors appear when I try to access the printer through the Printers Menu:
"Function address 0x60630d22 caused a protection fault. (exception code 0xc0000005) Some or all property page(s)may not be displayed."
Also, evertime I try to print from Internet Explorer, it asks me if I'd like to send an error report.
I just can't seem to figure out exactly what is going on. Any help would be greatly appreciated. Thank you very much for your attention and consideration. =)
-Anthony
"Function address 0x60630d22 caused a protection fault. (exception code 0xc0000005) Some or all property page(s)may not be displayed."
Also, evertime I try to print from Internet Explorer, it asks me if I'd like to send an error report.
I just can't seem to figure out exactly what is going on. Any help would be greatly appreciated. Thank you very much for your attention and consideration. =)
-Anthony