Networked ARS question

[caknfd]

Say I have 3 3300's connected via IP trunking. 1 phone controller and 2 trunking gateway controllers with one PRI each. In the ARS in the phone controller I send say 91+10 using a list (first choice TG#1 2nd TG#2) to TG#1 and its PRI is busy will the busy be past back to the phone controller so it can try its 2nd route in the list and send the call to TG#2 or do I have to use a list in TG#1 to pass the call over to TG#2
Both All three controllers have more IP trunks connecting themselves then PRI trunks so I can't use say 23 IP trunks to each Trunking Gateway to create the busy on the IP trunks as there is additional devices on the trunking gateways that need to be able to be reached.
My actual scenario has more controllers and they are not just trunking gateways I just want to try and make the question as simple as I could.
I can't seem to find the answer to this on MOL
Craig

 

[danramirez]

I am almost one hundred thousand percent, completely sure, that if all pri channels are busy on TG1, the second alternative on the phone controller will be used (i.e. phone controller will send the call over to TG2).

I had a similar scenario recently, only difference was I had SIP trunks on TG1 and TG2.

So, I think you won't need to configure a list on TG1, it will be enough that you configure your ARS list on Phone controller.

Test it and confirm to us all.

cheers,

daniel

http://www.hatkanatelecom.com

 

[kwbMitel]

I agree with danramerez for what its worth

**********************************************
What's most important is that you realise ... There is no spoon.

 

[Billz66]

Me too , have done it with Enterprise sip registrations to seprate MiVB's

If I never did anything I'd never done before , I'd never do anything.....