NEtwork Config Confusion

[techshoot]

We have a network with a main office, a remote office connected via frame relay router, and internet access with VPN. The internet access is new and I have recently inherited this configuration that was last administered about 4 years ago, only backups done in 4 years. I recently added the internet portion by installing a 2nd NIC card in the server and attaching it to a Cisco 827 ADSL router. None of my clients can access the router, though the server can, and I cannot get access to the network via VPN though it does authenticate at the router. I think it is due to the settings in the TCP on the server and clients and need some help.


Remote Office --> 4 clients (10.127.2.x)
|
Cisco 2620 Router (10.127.2.4
|
Frame Relay Connect
|
Cisco 2620 Router (10.127.1.4)
|
Cisco Catalyst 1900 Switch --> Clients (10.127.1.x)
| |
PDC Server (10.127.1.2) |
2nd NIC (10.127.5.2) Database Server (10.127.1.3)
|
Cisco 827 (10.127.5.1)
|
Internet Static IP --> VPN Clients

All the home office client gateways are set to 10.127.1.4 ant the remote office gateways are 10.127.2.4 with all netmasks at 255.255.255.0.

Any help on Config Would Be Appreciated

http://www.ktech-usa.com

 

[PAGEME1000]

One have you enabled IP forwarding on the server to allow communication from you're new nic card to you're old one....Can you do a tracert from you're vpn client to see how far it gets...

Page

 

[techshoot]

IP forwarding is enable and a tracert results in timeouts from the vpn clients. As I said, the vpn clients connect and are authenticated, which can be seen from the router, but nothing gets in.

http://www.ktech-usa.com