Netware w/Border mgr & VPN

[nadeemkhan68]

Is there anything I can do to the border mgr? I have purchased 5 BEFSX41 and a BEFVP41 to have 7 remote location get vpn access to the main building. Two of the remote locations have only one Windows XP PC. All of the sites have access to the internet via cable modem but only the main building gets an static IP address from the ISP. I have only tested it with one location using the BEFSX41 and connected. However I am unable to see the resources from the remote site... My netware system is configured with 10.0.200.0 IPs and a proxy server of its own. Internet access via the proxy server goes down when I configure the linksys router with 10.0.200.x IP address.
Below is the current configuration:

Main building VPN Router
DHCP = disabled
Internal TCP/IP:
192.168.8.1
255.255.255.0
External TCP/IP:
68.116.40.224
255.255.255.0
68.116.40.1
66.169.254.30
66.169.254.29
Local Secure Group: 192.168.8.0, 255.255.255.0
Remote Secure Group: 192.168.(tunnel # of the site).0, 255.255.255.0, Any for Windows XP PC
Remote Secure Gateway = any
Encryption = 3DES, Authentication = SHA, PFS = checked, pre-shared key = (individual keys for all sites)

Tunnel # 1 = Site 1: 192.168.1.0
Tunnel # 2 = Site 2: 192.168.2.0
Tunnel # 3 = Site 3: 192.168.3.0
Tunnel # 4 = Site 4: 192.168.4.0
Tunnel # 5 = Site 5: 192.168.5.0
Local Secure Group: 192.168. (tunnel # of the site).0, 255.255.255.0
Remote Secure Group: 192.168.8.0, 255.255.255.0, Gateway = 68.116.40.224
Encryption = 3DES, Authentication = SHA, PFS = checked, ‘keep alive’ is checked in the advanced settings