netware 65 and port 80 2200

[jrp611]

I have an issue that when I install netware 6.5 sp4 or sp5 to a new server after the install run tcpcon port 80,443 and 2200 are not there. but when I do and implace upgrade from netware 6.0 sp5 to netware 6.5 sp4 or sp5 then port 80,443 and 2200 show up also durning the install I ask for Imanager 2.5 from the install. any one see this before.

 

[marvhuffaker]

They won't show up if you don't install Apache. but you also have to make sure you start the services.

admsrvup
ap2webup

Those load the 2 default instances of Apache.

You also say that you're checking tcpcon and those ports are not listed.. But what service are you trying to run? What errors are you getting and where? I don't go digging in to TCPCON unless I am troubleshooting a specific service. Have you checked the IP Address Managment in the Portal? It will give you good information about what services are on what ports and ip addresses.

Marvin Huffaker, MCNE

http://www.redjuju.com

 

[jrp611]

apache, admsrvup,ap2webup are both loaded and in the autoexec.ncf the apache screen shows both port 443 and 80 and are listening on both ports. when I open a web browers for Imanager I can get in to Imanager with no problem it just seems strange that the ports are not listed in tcpcon.