I have a netware 6.5 server running DHCP and an ip address of 172.16.21.1 my DHCP scope is 172.16.21.50 to 172.16.21.150. I was running out of DHCP address and wanted to add more ip address to the scope. Is there a way to just add 20 more address to the stack or do I have to delete the scope that is running and reinstall it.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Netware 6.5 DHCP
- Thread starter jrp611
- Start date
goombawaho
MIS
Then choose this one
Section 5.3, Using the iManager Utility to Configure DHCP
marvhuffaker
MIS
iManager sucks for DHCP management. You can easily remove the "Address Range" and create a new one that is larger. But I would use the Novell DNS/DHCP Management tool that can be found under SYS
UBLIC\DNSDHCP. Much easier to understand what you are doing.
UBLIC\DNSDHCP. Much easier to understand what you are doing.- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question