Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Netpath Configuration Guide

Status
Not open for further replies.

DisasterMaster

Technical User
Feb 2, 2012
223
US
Can anyone tell me where I can get a NETPATH configuration guide?
I’m looking for commands that are available from the “NETPATH>” prompt.
 
XPAR will connect you to the host ports if that's what you needed
 
Thanks for the reply however, I'm looking to go much deeper than that.
What I really need is a manufacturer level password.
Without that, it will nor recognize commands like "DEFAULTNETWORK" which will show programmed IP Address, default gateway, subnet mask etc.
 
Does anyone know if there is a manufacturer level user name and password that will let me run commands like "DEFAULTNETWORK"?
I have credentials that will let me get access, however any command that I issue returns a response that says the command does not exist. If I issue a command like "help DEFAULTNETWORK" it will return a "help" description of the command thus indicating the command does exist. I read somewhere that I have to have a higher level credential to run the commands.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top