Netbuilder 432 as a frame relay switch

[dublklik]

Lots of questions from a new 3com owner.

Can I set up a Netbuilder 432 as a frame relay switch? Does it use the same serial cables as the 2500 series cisco routers? (I have some back to back DCE/DTE cables)
Anyone able to post a standard ISDN setup to test through an ISDN sim (pbx) without spids and using net-3.

Any help greatly appreciated. Thanks.

 

[Brat2]

Hi dublklik

It is impossible to use anu NETBuilder family router to act as FR switch. 3com has never implemented such feauture in these routers. If you want to use it back-to-back using Cisco cables you have to use PPP protocol on WAN ports. You can use Cisco back-to-back cables with no problems.

Brat