Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Netbuilder 227 - Path/Ports' status DWN
- Thread starter VEM
- Start date
Hi,
For ethernet is it enough to configure net addres and after just connect router to switch/hub. And before all of this you must enble control over this port. Try: menu<cr> you should get easy to use menu. You can also check 3com web support for this, you can find there all informations you need. For other ports it can be different, ie. serial/WAN.
Brat
For ethernet is it enough to configure net addres and after just connect router to switch/hub. And before all of this you must enble control over this port. Try: menu<cr> you should get easy to use menu. You can also check 3com web support for this, you can find there all informations you need. For other ports it can be different, ie. serial/WAN.
Brat
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question