Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need to create QoS for SNMP and Radius traffic on Cisco 4948 Switches

Status
Not open for further replies.
acabezas2014

acabezas2014

IS-IT--Management
Dec 2, 2013
6
US
Trying to create a QoS setup on my 2 Cisco 4948 switch across a point to point connection which is used for off site back. Link is really being utilized a lot by all this data being copied over the link. This is causing my SNMP monitor and radius to switch traffic to be slow and unresponsive. I would like to setup QoS on these two device to priorities traffic to SNMP and Radius. Anything anyone can start me off with would be great. Thanks
 
Status
Not open for further replies.

Similar threads

pbxcomm
  • Locked
  • Question
CISCO VG450
Replies
1
Views
297
bdk76
bdk76
Skip Rango
  • Locked
  • Question
how to backup cisco sg500-52p switch
Replies
1
Views
289
madwok
madwok
Jared R
  • Locked
  • Question
Cisco UC320W Paging Help
Replies
0
Views
265
Jared R
Jared R
Hayden09
  • Locked
  • Question
Cisco Sg-300 Flapping?
Replies
0
Views
285
Hayden09
Hayden09
JMarine0811
  • Locked
  • Question
CISCO VG450 Factory reset
Replies
1
Views
351
whykap
whykap

Part and Inventory Search

Sponsor

Back
Top