Does anyone have detailed notes on how to build a new T-1? I now bits and pieces but need some help. I know the D channel has to built and the trunk memebers also. I have an exisiting T-1 that I need to out, then rebuild with a new T-1 type NI2 in to an exisiting route (54) and add to exisiting members in that route. LD 15 and 16 are the two loads that is done in right?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Need to build a new PRI T-1 ON Opt. 81C
- Thread starter plshlp123
- Start date
you have the jest of it, the 1st thing is out the trunks, out the route then out the loop in the cequ, the put the pri back in the cequ, add the dch, then add the route and the trunks.. if you use the same route you will not need to rebuild the rlb's in 86. if this is the 1st pri, two things to check, in net data make sure isdn is yes and make sure you've got a entry for ldn in the cdb.. that is the only place to tell the switch how many digits you're going to get via pri did or dnis
john poole
bellsouth business
columbia,sc
john poole
bellsouth business
columbia,sc
- Status
Similar threads
- Locked
- Question
- Locked
- Question