Need Help To Change Optra T614 IP Address

[wbcsas]

This printer had been working fine until I changed Service Providers and changed the TCP/IP to Obtain an IP Address Automatically.
The printer still has the old IP Address given to it and I do not know how to change it. If I change my IP Address back to what it was, the printer works fine but I have no Internet.

 

[Michael52x]

Unplug network cable. Do a cold re-set. This will clear the NIC. Then re-connect and start up. Make sure on the printer panel I\O menu, that TCP/IP is set to DHCP.
Print the config page, and go to driver and make changes to port.

"Impatience will reward you with dissatisfaction" RMS Cosmics'97

 

[wbcsas]

Michael52x I thank you ver much for your help, the network printout I receive states that DHCP, BOOTP, RARP are all set to disable, Address Source is set to Manual.
The problem is I cannot find the I\O Menu you have described, I have printed out a list of all the menus but cannot find a I\O menu and cannot find where the DHCP or the Address Source can be changed.

 

[mrregan]

You should have a network or interface menu.