Need help imaging a BCM200 v3.7 2

[atascoman]

I can't get the BIT to boot from either an IDE or USB CD-ROM. I also tried running it from my PC but it appears to be a ghost file so XP won't run it.

The docs said to connect the IDE CD-ROM to the available connector, which there wasn'tone so I tried to connnect it with another IDE cable to the PL7 connector and also by replacing the single IDE cable with a dual so I could connect both the HD and the CD-ROM up at the same time.

Any suggestions on how best to do this or do you have to have a BCM400 chassis to do images since it has the extra gear.

 

[MagnaRGP]

The ghost files are on the disks included with the BCM and are non-bootable. The BIT is a separately purchased disk.

 

[3Sixty]

You can use the ghost application providing you use the following command in dos interactive mode.

"ghost -clone,MODE=load,SRC=R:\37GA_BIT.GHO,DST=1,SZEE -ntchkdsk -sure –auto

and replace R:\37GA_BIT.GHO with the path to your ghost-image"

Marshall

http://www.nortelsupport.net