Need help configuring port forwards 1

[tamray]

I need to configure a pix to allow external access to an internal IP camera system.
This is what I need:
(The public IP is the same for all access)

outside IP PublicIP:805 routed to camera controller 1 at 10.10.18.21
outside IP PublicIP:806 routed to camera controller 2 at 10.20.18.21
outside IP PublicIP:807 routed to camera controller 3 at 10.20.18.22
and so on for at least 15 controllers.

 

[Supergrrover]

Take a look at this -

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080862017.shtml

This is more what you are looking for but the first gives a good run down and this is for specific ports when you have one ip. -

http://www.cisco.com/en/US/products...s_configuration_example09186a00807d287e.shtml

You will need one ACL entry and one static port mapping for each port.

If you run into trouble, post your config.


Brent
Systems Engineer / Consultant
CCNP, CCSP