Need Help Adding a DID on my Nortel MICS 7.0 Telephone System.

[imwadej]

I have a Nortel MICS Telephone System with 7.0 Software. I have a PRI with several DID numbers assigned. I am needing to reassign one of the DID numbewrs to another extension. Can anuone help me?


Wade Jones
TelTERRA Communications, LLC.,

http://www.telterracom.com

SC Communications, INC.,

http://www.sccommunications.com

 

[curlycord]

Assign target lines to the set with appearances as required.

If you have no idea what I said then best you call a tech in to program.

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[imwadej]

If you can be a little more specific I would appreciate the assistance. I am a technician and am familiar with the basic programming and believe it or not I programmed the DID's that are on the system now. I had a stroke 3 years ago and have some difficulty remembering the areas to go to to program. It may come back to me but just needed a little direction.
I know how to go in the programming and maneuver around so you can skip that part and tell me the areas such as stations or trunks or both.

I appreciate any help.


Wade Jones
TelTERRA Communications, LLC.,

http://www.telterracom.com

SC Communications, INC.,

http://www.sccommunications.com

 

[exsmogger]

Look under Terminals & Sets - Line Access - Line Assignment. Unassign the target line from the current extension and then assign to the new extension.

Brian Cox
Oregon Phone

http://www.OregonPhone.com

http://www.linkedin.com/in/briancox1952

 

[curlycord]

Target lines start at 157
One you assign the target then SHOW again and add as many appearances as needed
i.e give reception 4 or 5 on mid size system.

You may want to go under Lines and change the Prime set as well to equal the set you assigned.






=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[Crowtalks]

To build upon curlycord...

Each taget line is assigned to ring, A&R or APP just as loop lines in the terminal & sets programming field. To find what target line a particular DID is assoiciated with, look at the DN and see what target line is assigned to it.

Each DID is assigned in the system as a received number within a particular target line, and that target line is then assigned to a prime set under that individual target line.

Jim

"If I had known it would turn out like this, I would have became a locksmith" Albert Einstein

NCSS NCTS NCTE CS1000E
Mitel 3300 4.2 basic & advanced, 5000 4.0, NuPoint I&M 4.2