I will be installing an additional LSP to an S8710 server next week. I am attempting to program the IP Network Region for the site; however, when I attempt to program the Connection Management from region 6 (the new LSP) to region 5 (the Meeting Exchange), it tells me that I "Cannot limit bw if NoLimit is in the other WAN-BW-limit field," even though both Total and Video WAN-BW-limits are set to NoLimit. Even if I don't try to program 6 --> 5, and only worry about 6 --> 1, 6 --> 2, and 6 --> 4 and program them as pstn for IGAR, I cannot save the form because it gives me the same message. I have checked two other Network Regions and verified that both Total and Video WAN-BW-limits are set to NoLimit. Any suggestions would be greatly appreciated. Thank you very much!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Need assistance in programming IP Network Regions
- Thread starter Nooges
- Start date
steeltown89
MIS
Take the 0 out in front of the No Limit field and it will allow you to make it No Limit then. Annoying field default pops up with Kbits if you don't remove the zero in front it won't let you change it to "No-Limit".
- Status
Similar threads
- Locked
- Question