Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NEC Topaz Line Port Setup

Status
Not open for further replies.

weealbie

Technical User
Aug 18, 2016
1
AU
Hi guys, first post on here so apologies if it's been answered already.

I have an NEC phone system with NEC IP2AT phones. Function keys 1 - 6 are setup and line ports on every phone except one where keys 4, 5 and 6 are not defined.

I need to set them up as line port 4, 5 and 6 but the programming is not allowing me to. Is there something i am missing with the coding?

Any help would be greatly appreciated.
 
To program a line key on a handset :-
1. Press idle CALL key.
2. Dial 852.
3. Press the key you want to program.
4. Enter the 3-digit key function and any additional information needed for the key.
Available functions are *00-*99 (refer to chart) and line keys 001-200.
To un-define a key, enter 000.
When a key is programmed using service code 852, that key cannot be programmed with a function using the 851 code until the key
is undefined (000).

The code for a line key is *01 then 3 digit line ie 004 for line 4
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top