NEC Sv8300 Caller ID Showing DDD on phones after cutover

[tkrauss]

A new Fiber circuit was installed then the caller ID now shows DDD.
The Fiber SIP is converted to PRI in a Cisco 2911.
The expected digits are set to 4. Protocol NI-2

Here is a shot of a debug screen that was provided: The 1111111111 and 999999999 replaced the actual phone numbers.
Feb 13 21:45:57.937: ISDN Se0/0/1:23 Q931: TX -> SETUP pd = 8 callref = 0x10DF
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98381
Exclusive, Channel 1
Display i = '1111111111 1111111111'
Calling Party Number i = 0x0080, '+11111111111'
Plan:Unknown, Type:Unknown
Called Party Number i = 0xA1, '9999999999'
Plan:ISDN, Type:National

Any Ides would be appreciated.

 

[belevedere]

Was a new route added to the 8300?

 

[tkrauss]

No. We have two PRI's.
We have the existing two routes 10 and 20

 

[belevedere]

If CID existed before the change in services and nothing in the 2000 IPS was changed, then the issue is most likely with Cisco.

 

[tkrauss]

I have the provider looking. It has been a battle to have them try and find a resolution.
Thanks for replying

 

[tkrauss]

Does anyone have an output like I show in the start of the thread I could compare to?