NEC SV8100 - Reset to Factory Default. 1

[Warrenator]

Hello.

I have a couple of NEC SV8100 units, I need to reset them to factory default for new installation use.

How do I restore them to default, and is there any license info stored on the system that could be lost by doing so?

I would be very grateful of any assistance anyone could provide my in doing this, many thanks.

 

[belevedere]

The licensing will remain.
Power down, press and hold the load button, power up count to 10 then release the load button.

 

[belevedere]

The blades are self learning, so if you do not want any of them assigned for you remove them from the cabinet before you default the system.

 

[Warrenator]

Job done, thank you kindly!