Nec Neax 2400

[Redlabel]

Hello.
I have connected a PC with Callmaster(Ringmaster) to the seriell port on my Neax 2400, but I am not getting any signal from the PBX. The PC is beeing used to keep track of phonecalls that are beeing made and to calculate the charge. I have set the port on the PC to 1200, 7, 1, even. Is this correct? Before there was a printer connected to the seriell port. What other changes must i do to get a signal? What kind of kabel must I use?

Eirik Nergaard
Bravida Nord

 

[OMBD]

Try a null modem cable at 1200, Even, 7 and 1 on the serial port programmed for SMDR. Your NEC cable should be a CA-1 type.
Hope this helps.

Jerry Pannell

http://www.SCLB.com

techs@sclb.com