Hello, I have a 2000IPS with another tenant added. We are using LCR and phones in tenant 1 are going out using trunks in tenant 1. LCR was set up properly. Another tenant has moved in and they also have 2 CO trunks. Can someone break down LCR for tenant 2 so that when tenant 2 dials out using (9) A126,,,,, it will use only CO lines place in tenat 2 using the 12 and 35 commands.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NEC IPS LCR FOR 2 TENANTS WITH 2 DIFFERENT TRUNK GROUPS
- Thread starter Antwis79
- Start date
OzzieGeorge
Programmer
Not the easiest programming job for someone who is inexperienced. first check the FAQ here....
This may give you an idea of what you are up against. You will need to modify all 8a4000 (assuming that is the one used) entries, set up the tennant development in 8a1000 to 8a1015 then create the new entries in commands 8a0000 to 8a0255 and the associated 8a5xxx entries (possibly also 8a9000 too)!
The trick would be to work out what you need to enter and leave the Cmd 8a4000 entries till last, you can then change them one at a time to test them.
This may give you an idea of what you are up against. You will need to modify all 8a4000 (assuming that is the one used) entries, set up the tennant development in 8a1000 to 8a1015 then create the new entries in commands 8a0000 to 8a0255 and the associated 8a5xxx entries (possibly also 8a9000 too)!
The trick would be to work out what you need to enter and leave the Cmd 8a4000 entries till last, you can then change them one at a time to test them.
- Status
Similar threads
- Locked
- Question