I am getting my system up and learning it quickly, but am stumped.
I have connected an incoming line to CO1. The board light that corresponds to line 1 lights up red when the line is connected and goes off when disconnected.
I have tested the line on pins 4 and 5 on the cat5 cable and it is coming in fine.
I cannot get any extension to call out. When I call in I get a busy signal.
I would greatly appreciate any input.
I have connected an incoming line to CO1. The board light that corresponds to line 1 lights up red when the line is connected and goes off when disconnected.
I have tested the line on pins 4 and 5 on the cat5 cable and it is coming in fine.
I cannot get any extension to call out. When I call in I get a busy signal.
I would greatly appreciate any input.
