NEC 2400IPX SMDR

[ethereal112]

Tried checking my IO card port for SMDR data, doesn't look like nothing's coming out. Can someone verify the testing parameters for a terminal connection to see raw data off the IO card? baud rate 9600, hardware none, parity bit 8. Anything else? Much appreciated!

 

[3racefan3]

Baud rate ETC. will depend on what the I/O board is programmed for. Go into AIOC (if we are working on a 2400) terminal type should be 4 for the port that is to send SMDR and check the port. In the old days 1200 E 7 1 was used quite a bit for SMDR.