Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NEC 2000 IPS MCI Link programming
- Thread starter 3000gt
- Start date
MCI Programming on MP Port
CM4000>0 or 1>10 (sets MP RS port to MCI, if using RS1 make sure SW1 bit 4 is off)
CM4013>0 or 1>0 (* in some cases this may need to be set, test before setting)
Set 40xx commands accordingly to match your VM
CM0401>01>0 or 1 (connection port for MCI)
CM08>708>0 (sets station field to 6 digits in length)
CM08>709>0 (optional, turns on expanded MCI)
CM08>443>0 (VMS with MCI)
CM08>444>0 (message waiting lamp control from MCI)
Set CM1310 to a 0 for VM pilot and ports
Set CM1322 to a 0 for VM pilot and ports
Use a RS-RVS-4S CA-C cable
CM4000>0 or 1>10 (sets MP RS port to MCI, if using RS1 make sure SW1 bit 4 is off)
CM4013>0 or 1>0 (* in some cases this may need to be set, test before setting)
Set 40xx commands accordingly to match your VM
CM0401>01>0 or 1 (connection port for MCI)
CM08>708>0 (sets station field to 6 digits in length)
CM08>709>0 (optional, turns on expanded MCI)
CM08>443>0 (VMS with MCI)
CM08>444>0 (message waiting lamp control from MCI)
Set CM1310 to a 0 for VM pilot and ports
Set CM1322 to a 0 for VM pilot and ports
Use a RS-RVS-4S CA-C cable
- Status
Similar threads
- Locked
- Question