NEAX 2400 DTERM IP VLAN

[sos2715]

Each cube we have two seperate network connections for PC and Phone. We want to use one network connection and hub the PC off the phone but we want the PC and Phone on two seperate VLAN's

Our network is setup for VLANS and the PBX and phones are currently on a seperate VLAN.

On the phone in VLAN settings I enabled VLAN Mode and and entered in the VLAN ID is there anything else I need to do?

Steve

 

[OzzieGeorge]

You could check out the cheat sheets here.

http://www.2000stuff.com/

 

[pave35]

If you use a VLAN tag at the phone set, the voice data will be taged with the VLAN id while the PC data will not be tagged so it will follow the default VLAN of the switch port it is connected to.
New versions of the IP Dterm software (3.08)allow you to tag the voice with one ID and the PC data with another ID.
You will also need to make sure the MP and IP PAD card are also set for the same VLAN ID.

 

[sos2715]

There's an AUX VLAN setting in the network switch(We use Cisco) that you need to set to the VLAN your phones are on.

Steve