Neax 2000 IVS and Payphones 2

[neaxtester2000]

I recently purchased a payphone to test and see if it could work with our PBX. Now after doing some testing i've come to realize that the analog station from the PBX is supplying 23v. The payphone requires 48v to operate the coin dispenser. Is there a way to control the voltage the PBX outputs per station or system wide? Thanks

 

[pabxdude]

neaxtester;

if you replace the current analog card with a AUCA card, this will provide the extra voltage. Only down side, its a 2 port card.

thanks.

 

[neaxtester2000]

is there any configuration required to setup this card up, or do I just plug it in and assign a station to it?

 

[pave35]

Plug it in and assign a station number and that's it.
It also helps to cross connect to the cable the device is wired to.