good on 2400s(10+ years) not much seat time with 2000. I have a 2000IPS with a mix of DTerm i and analogs, mix of DIDs and NON-DIDs. I need to: 1) change a DID DTerm to a NON-DID number. Change number with CM10. no problem. 2) build "new" analog with previous DID number(from DTerm). cm10, len number of analog, DID number. no problem. Now for 3) I need to have analog DID show on DTerm. cm9000 xxxx (DTerm number),01(key number)DE xxxx(analog sta number)EXE and it takes the program but it does not work as desired.(I wish this was a 2400, AKYD and I'm outa there.) the key on the DTerm is always green!!?? It does not ring in on the DTERM, but the analog station works fine.... What piece of the pie am I missing??? Any help GREATLY appreciated....
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NEAX 200 IPS station assignment/appearance 1
- Thread starter ankledeep
- Start date
-
1
- #2
- Thread starter
- #3
Thank you!!! I looked up cm12 in the command manual, and low in behold, I had yellow highlighted the thing..... I just don't do enough work on our 2000 switches..... or it's the over 50 thing!!!! again, THANK YOU !!!! maybe it's a mental thing, I still like the 2400 better (more comfort!!)
- Status
Similar threads
- Locked
- Question