Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NCP500 and SIP Trunks (Blueface) 1
- Thread starter mhlduffy
- Start date
-
1
- #2
obtsystems
Programmer
this is the inter-digit timer, you can adjust it, but if too short it will time out if you pause between numbers, I find about 4 seconds for the second digit timer.
another option is to dial # at the end of dialing, this will tell the system you have finished dialing and will connect straight away
another option is to dial # at the end of dialing, this will tell the system you have finished dialing and will connect straight away
Better still
In Group>Trunks>Dialing Plan (3.1.4) enter the usually dialled first digits the the corresponding number of X's
eg QLD area code is 07 number is 40567890
NSW area code is 02 number is 90123456
enter 07XXXXXXXX;40XXXXXX;02XXXXXXXX;90XXXXXXin the table
where X is the nuber of digits the PBX should wait for before sending the number.
The PBX will wait for these digits before sending the number, voila
In Group>Trunks>Dialing Plan (3.1.4) enter the usually dialled first digits the the corresponding number of X's
eg QLD area code is 07 number is 40567890
NSW area code is 02 number is 90123456
enter 07XXXXXXXX;40XXXXXX;02XXXXXXXX;90XXXXXXin the table
where X is the nuber of digits the PBX should wait for before sending the number.
The PBX will wait for these digits before sending the number, voila
- Status
Similar threads
- Locked
- Question
