I'm running Naviscore 05.00.03.02 with BSTDX SW 4.4.2.4. When i try to see what code is on the Flash partitions on the BSTDX in the download switch software or set default switch software window, the screen says "none", when it clearly shows from the cli using sho soft flash.
If i do the same for the CBX and GX switches this is fine.
I'm using SanDisk 440Mb Flash cards and SiliconTech 448Mb Flash cards.
I can SNMPWALK the switch so it's not an SNMP problem. I cannot find the particular SNMP OID needed to see the flash image or i could script it.
I don't get a timeout in the window, it just shows no image.I also get a trap saying reveived event 1.3.6.1.4.1.8940.3.1.0.1006 - no format in trapd.conf.
So i'm guessing that we've had a software upgrade that has altered the MIB table entries and we will have to reload the MIB?????
Any suggestions would be greatly received?
If i do the same for the CBX and GX switches this is fine.
I'm using SanDisk 440Mb Flash cards and SiliconTech 448Mb Flash cards.
I can SNMPWALK the switch so it's not an SNMP problem. I cannot find the particular SNMP OID needed to see the flash image or i could script it.
I don't get a timeout in the window, it just shows no image.I also get a trap saying reveived event 1.3.6.1.4.1.8940.3.1.0.1006 - no format in trapd.conf.
So i'm guessing that we've had a software upgrade that has altered the MIB table entries and we will have to reload the MIB?????
Any suggestions would be greatly received?