Nat on multilink

[gpetrom]

Hi everyone

I have configured an 876 router with two wan interfaces one is
an adsl over atm and one is pppoe. How must I configure the nat translation so both wan interfaces to work.
An example it would be usefull

Thanks all in advanced.

 

[DanInRaleigh]

use floating static routes.. like below..just pretend you are using your dsl encapsulations...

..when the router detects your primary route is down...it will route out backup interface because it has a higher distance metric...

http://www.cisco.com/en/US/tech/tk801/tk133/technologies_configuration_example09186a0080093f7e.shtml

...you can create access-lists for both inside and outside.

..you will be applyin *nat outside* to both outside interfaces...(same access-list can be applied to both wic interfaces)..

http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a0080093e51.shtml

..i think this makes since..

CCNP,CCSP,MCSE,Sec+,Net+,A+...