Nat command on Pix

[18121999]

Hi guys,

I'm hoping you can help me with this. I have set up a Cisco Pix firewall with vpn tunnels to 3 sites, I need to define that I do not want these ip addresses nat'd but I understand you can only have one nat 0 statement applied to an interface and I tried to put in 3 nat 0 commands all applied to the Inside interface.
I am a Pix newbie, in case you have already deduced that by my dumb question!!
How do I go about doing this? please help..........
Thanks.

 

[lgarner]

Create an access list to identify the traffic, then use the access-list in the nat command.