NARS with TIE lines or DID lines

[ArturoMonterrey]

hello everybody.

how can I configure an Meridian Option 11c with a card DTI2 (MFCDR2) with a PBX Definity?

The trunk type is "TIE", isn´t it?
This is programmed in LD 14, 15 16 and 17, isn´t it?


I have the connection between Meridian and Definity, but the Route in Meridian are type DID, and when I want to call to the definity, the call is not complete if I dial slow the number.


Would someone help me.

 

[johnpoole]

both ends need to be either tie or did, as long as they match. i would use qsig on both ends, takes away all the guess work. if both end have that as an option then you don't have a problem. dialing slow of fast makes no difference, the switch collects the digits and sends them out aa a data packet, no digits are sent until the end of dial timer says go. is this t1, e1 pri or analog? if analog what is the start type?

john poole
bellsouth business
columbia,sc