Name Presentation on between BP250 & Cisco CUCM

[MrTek8]

Hi,

I have networked a BP250 & Cisco call manager 9.0. Calling between the two systems works fine. However, only the calling/called number is shown on screen of the parties, the name is not presented.

Does anyone know what to configure on the BP250 or call manager to have the name transimiited and presented to the parties? Will appreciate your assistance.

 

[Njoro82]

Hi,
BP250 does not support clip on h323 trunk to cisco or other vendor pbx. Cisco can send name ID to BP250,but BP is not able to interpret that,instead it will display the trunk codes on the IPLU,so disable sending of names from cisco. Under route pattern,calling party transformations and connected party transform,set name presentation to restricted.