extn name is not showing between two sites.sites are having 61c.between 2 sites i have 2mb lease line configured with SL1 protocol,I have tried putting RCAP value as nd1/nd2/nd3 but no luck..any input??
RCAP is set with the D channel in Ovl 17. The link must be taken down before it can be set...... Use ND1 or ND2.
ND1 is for the name to be displayed AFTER answer, & is the method by which Rlse 16 works .
(Note :- There is no RCAP prompt in Rlse 16)
ND2 is for the name to be displayed during ringing & for the called name to be displayed on the callers set on xtn - xtn calls. This is a feature for rlse 18 onwards. .....................(more below) The RCAP prompt accepts a list, so ND2 can be entered along with NCT etc.
Is your link configured as Q931?. If so, then has the RDB "SIGO" been set at ESN5?. Here are my very old configuration notes that may help below.
Q931_A.TXT
CONFIGURATION OF Q931 ROUTE ** A END ** (OPTION 11 18.40H)
08/05/1996
>LD 17 ##### CONFIGURATION #####
REQ CHG
TYPE CFN
ADAN
PWD2
PARM
CEQU YES ------------------ CHANGE COMMON EQUIPMENT CONFIGURATION
DDCS
TDS
CONF
DTDT
DLOP
PRI2 3 ------------------------- CARD/LOOP No. FOR PRI CARD
APVL
DTI2
MTYP
SMEM
OVLY
VAS
FRPT
MANU
CLID
MGCR
DCUS
MAGT
ATRN
MSCL
CFWS
REQ CHG
TYPE CFN
ADAN NEW DCH 14 ------------------ CONFIGURE D/CHANNEL
CDNO 3 ------------------ CARD No.
PORT 1 ------------------ PORT (ALWAYS 1 FOR PRI)
DES Q931 ------------------ DESIGNATOR
DPNS NO ------------------ YES = DASS/DPNSS NO = Q931
USR PRI ------------------ PRIMARY RATE INTERFACE
DCHL 3 ------------------ LOOP/CARD No.
PRI2
OTBF
IFC SL1 ------------------ INTERFACE TO MERIDIAN/SL1
SIDE NET ------------------ NET = A END USR = B END
RLS 18 -------------- RELEASE OF S/W ON DISTANT MERIDIAN
RCAP MSL ------------------ REMOTE CAPABILITIES
RCAP ND2 MSL = DISTANT SWITCH RUNNING REL 18 S/W
RCAP NCT WITH MSDL CARD AS D/CHANNEL INTERFACE
RCAP ND1 OR ND2 = NAME DISPLAY METHOD 1 OR 2
MBGA NCT = NETWORK CALL TRACE SUPPORTED
NASA YES --------------- NETWORK ATTENDANT SERVICE ALLOWED
LAPD
>LD 73 ##### PRI2 PAD TABLE & LOOP TIMERS #####
REQ NEW
TYPE PRI2 ------------------------ 2.0 Mb/s PRI CARD
FEAT PAD ------------------------ S/W PAD CATEGORY
PDCA 2 ------------------------ PAD CATEGORY TABLE
DFLT
ONP 15 15 }
OPX 15 15 }
DTT 15 15 }
DCO 15 15 }
NTC 15 15 }
TRC 15 15 }
DTR 15 } -------------------- 15 = 0 dBs (NO PAD)
VNL 15 15 }
ACO 15 15 }
AFX 15 15 }
ADD 15 15 }
PRI 15 15 }
DSET 15 15 }
REQ CHG
TYPE PRI2 ------------------------ 2.0 Mb/s PRI CARD
FEAT LPTI ------------------------ LOOP TIMERS
LOOP 3 ------------------------ LOOP/CARD No.
MFF
ALRM
G1OS
SLP 5 24H 255 1H ---------------- SLIP COUNT
BPV
CRC
FAP
RATS
GP2 50 100S 12S 12S 4S ---------- GROUP 2 ERROR THRESHOLDS
MNG1 30S ------------------------- MAINTENANCE GUARD TIME GROUP 1
NCG1 30S ------------------------ NO NEW CALLS GUARD TIME GROUP 1
OSG1 1M ---------------------- OUT OF SERVICE GUARD TIME GROUP 1
MNG2 30S ------------------------- MAINTENANCE GUARD TIME GROUP 2
NCG2 30S ------------------------ NO NEW CALLS GUARD TIME GROUP 2
OSG2 30S ---------------------- OUT OF SERVICE GUARD TIME GROUP 2
PERS
OOSC 0 ------------------------- OUT OF SERVICE COUNTER
>LD 14 ##### TRUNKS #####
REQ NEW 10
TYPE TIE ------------------------- TRUNK TYPE
TN 3 1 ------------------------- LOOP/UNIT
PDCA 2 ------------------------- PAD TABLE
PCML A ------------------------- PCM LAW
CUST 0 ------------------------- CUSTOMER NUMBER
NCOS 7 ------------------------- NETWORK CLASS OF SERVICE
RTMB 2 10 ------------------------ ROUTE/MEMBER
B-CHANNEL SIGNALING
INC NO ------------------------- DEFAULT = YES
MNDN YES = INCREMENT TN & MEMBER
TGAR NO = INCREMENT TN & DECREMENT MEMBER
CLS DTN ------------------------- DIGITONE
TKID
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.