Mxone 6.2 SP1: How to dynamically truncate incoming digit on analog trunk TLU83

[Starc]

HI guys,

We are using Mxone 6.2 SP1 with analog trunk card TLU83 connecting to PSTN.
Analog trunk incoming landing is given to SIP phone extension- 3901 by cmd: RODNI:ROU=1,DAY=3901,NIG=3901;
Now whenever external mob is calling on trunk line which rings on 3901 show display --> 091 8877665544. Here 91 is India country code.

If local landline calls on same trunk line display shows ---> 22 3096 31XX. Here actual area code is 022

Now I need to digit manipulate the above external calling party. Need to remove 91 from mob number & display should shows 08877665544.
Also in locals calls I need to add 0 , so that display changes to 022 3096 31XX

How to use number_conversion in Mxone

 

[snor]

Hi,
first check if number conversion is allowed for route 1 ROCAP: SERV-Parameter D10 = 1)

then try following entries :

--> "local landline calls" (11...89)
number_conversion_initiate -entry 1 -route 1 -conversiontype 2 -numbertype 0 -pre 0
number_conversion_initiate -entry 2 -route 1 -conversiontype 2 -numbertype 0 -pre 0
...
number_conversion_initiate -entry 7 -route 1 -conversiontype 2 -numbertype 0 -pre 0
number_conversion_initiate -entry 8 -route 1 -conversiontype 2 -numbertype 0 -pre 0

--> "external mob" (091..098)
number_conversion_initiate -entry 09 -route 1 -conversiontype 2 -numbertype 0 -truncate 3 -pre 0

P.S.
I hope this will work, haven`t tested numberconversion with analog trunks.

BR.
Norbert
________

 

[Starc]

Thanks Snor for your inputs, will update soon on this.